Для оформления заявки добавьте оборудование
в корзину и сформируйте заказ
Доставка в любой регион России транспортной
компанией на Ваш выбор
| Параметр | Значение |
| Общие характеристики | |
| Артикул | 93093 |
| Материал | housing: polycarbonate, 10 % glass fiber reinforced |
| Ripple | ≤ 10 % |
| Ambient temperature | -20 ... 60 °C (-4 ... 140 °F) |
| Storage temperature | -40 ... 70 °C (-40 ... 158 °F) |
| Degree of protection | IP20 |
| Connection | X20: terminals 1, 2 |
| Mass | approx. 380 g |
| Fusing | 2 A , in each case for 8 modules |
| Electromagnetic compatibility | NE 21:2017 For further information see system description. |
| Mounting | on 35 mm DIN mounting rail acc. to EN 60715:2001 |
| Voltage drop | 0.9 V , voltage drop across the series diode on the termination board must be considered |
| Marking | II (1)G [Ex ia Ga] IIC II (1)D [Ex ia Da] IIIC I (M1) [Ex ia Ma] I |
| Output type | volt-free contact |
| Dimensions | 108 x 200 x 163 mm (4.25 x 7.9 x 6.42 inch) , height including module assembly |
| Reverse polarity protection | yes |
| Core cross-section | screw terminals: 0.25 ... 1.5 mm (24 ... 12 AWG) |
| EU-type examination certificate | CESI 06 ATEX 022 |
| IECEx approval | IECEx CES 06.0003 |
| Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. |
| Designation | optional accessories: - HART multiplexer master HiDMux2700 - label carrier HiALC-Hi*TB-SET-1** |
| Approved for | [Ex ia Ga] IIC [Ex ia Da] IIIC [Ex ia Ma] I |
| Contact loading | 30 V DC, 1 A |
| Directive 2014/30/EU | EN 61326-1:2013 (industrial locations) |
| Directive 2014/34/EU | EN 60079-0:2012+A11:2013 , EN 60079-11:2012 , EN 50303:2000 |
| Supply | pluggable screw terminals , black |
| Display elements | LED PWR1 (termination board power supply), green LED LED PWR2 (termination board power supply), green LED LED FAULT (fault indication), red LED - LED lits: module failure - LED flashes: power supply failure |
| Field side | explosion hazardous area: 4 screw terminals per module , blue |
| Control side | non-explosion hazardous area: 1 25-pin Sub-D connector |
| Power dissipation | ≤ 500 mW , without modules |
| Control drawing | 116-0327 |
| Maximum safe voltage | 250 V (Attention! U is no rated voltage.) |
| Nominal voltage | 24 V DC , in consideration of rated voltage of used isolators |
| Field circuit/control circuit | safe electrical isolation acc. to IEC/EN 60079-11, voltage peak value 375 V |
Сравнение
Избранное
