Для оформления заявки добавьте оборудование
в корзину и сформируйте заказ
Доставка в любой регион России транспортной
компанией на Ваш выбор
Параметр | Значение |
Общие характеристики | |
Артикул | 70382 |
Operating voltage | 10 ... 30 V DC , ripple 10 % |
No-load supply current | ≤ 50 mA |
Repeat accuracy | ≤ 0.1 % of full-scale value |
Switching frequency | ≤ 14 Hz |
UL approval | cULus Listed, General Purpose |
CCC approval | CCC approval / marking not required for products rated ≤36 V |
Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
Degree of protection | IP67 |
Housing | PA-GF35 |
Mass | 115 g |
Interface type | Serial interface (programming adapter required) 9600 BPS, no parity, 8 data bits, 1 stop bit |
Voltage drop | ≤ 2 V |
Pulse length | 0.5 ... 300 ms (level 1) |
Temperature influence | < 1.5 % of full-scale value |
Output type | 2 switch outputs NPN, NO/NC, programmable |
Connection type | Connector plug M12 x 1 , 5-pin |
Standards | EN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 |
LED green | Operating display |
Input/output type | 1 synchronization connection, bidirectional |
Supplementary information | Switch settings of the external programming adapter: "output load": pull-up "output logic": inv |
Adjustment range | 50 ... 500 mm |
Sensing range | 35 ... 500 mm |
Dead band | 0 ... 35 mm |
Standard target plate | 100 mm x 100 mm |
Transducer frequency | approx. 380 kHz |
Response delay | minimum : 20 ms factory setting: 55 ms |
LED red | error |
Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
Rated operating current | 200 mA , short-circuit/overload protected |
Range hysteresis | programmable , preset to 1 mm |
Output rated operating current | < 12 mA |
Level | 4 V ... U |
Input impedance | > 12 kΩ |
Output 1 | near switch point: 50 mm far switch point: 500 mm output function: Window mode output behavior: NO contact |
Output 2 | near switch point: 100 mm far switch point: 250 mm output function: Window mode output behavior: NO contact |
Beam width | wide |
Common mode operation | ≤ 70 Hz |
Multiplex operation | ≤ 90 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) |
LED yellow 1 | switching state switch output 1 |
LED yellow 2 | switching state switch output 2 |
Pulse interval | ≥ 14 ms (level 0) |
Evaluation procedure | averaging (MxN) M = 5 N = 2 |