Пт-Пн: 9:00 - 18:00
Для оформления заявки добавьте оборудование
в корзину и сформируйте заказ
Цены носят информационный характер и не являются публичной офертой. Точную цену и срок поставки подтвердит менеджер при оформлении заявки
Доставка в любой регион России транспортной
компанией на Ваш выбор
| Параметр | Значение |
| Общие характеристики | |
| Артикул | 54410 |
| Operating voltage | 20 ... 300 V DC / 20 ... 253 V AC |
| Switching frequency | 0 ... 25 Hz |
| UL approval | cULus Listed, General Purpose "For use in NFPA 79 Applications only" For overcurrent protection, install a fuse with a rated current of max. 3 A and at least 300 V AC/DC |
| CCC approval | Ue 75VDC - 250VDC Ue 75VAC - 230VAC |
| Ambient temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Degree of protection | IP67 |
| Time delay before availability | ≤ 300 ms |
| Voltage drop | ≤ 5 V (typ. 2V) DC operation ≤ 8 V (typ. 2V) AC operation |
| Protection class | II |
| Operating current | 5 ... 500 mA |
| Output type | 2-wire |
| Switching function | Normally open/closed (NO/NC) |
| Rated operating distance | 40 mm |
| Installation | non-flush |
| Output polarity | AC/DC |
| Assured operating distance | 0 ... 32.4 mm |
| Reverse polarity protection | reverse polarity tolerant |
| Short-circuit protection | pulsing |
| Switching state indicator | LED, yellow |
| Connection type | terminal compartment |
| Housing material | PA 6.6 / metal |
| Sensing face | PA 6.6 |
| Hysteresis | 1 ... 10 typ. 5 % |
| Off-state current | ≤ 1.5 mA |
| Standards | EN 60947-5-2:2007 EN 60947-5-2/A1:2012 IEC 60947-5-2:2007 IEC 60947-5-2 AMD 1:2012 |
| Core cross-section | up to 2.5 mm |
| Rated impulse withstand voltage | 2.5 kV |
| Rated insulation voltage | 230 V |
| Operating voltage indicator | LED, green |
| Error indicator | flashes when overcurrent |
| Momentary current | 0 ... 3000 mA |
| Actual operating distance | 36 ... 44 mm typ. 40 mm |
| Rated operating voltage | 24 ... 250 V DC / 24 ... 230 V AC |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 % |
| Minimum core cross-section | without wire end ferrule 0.5 mm , with connector sleeves 0.34 mm |
| Maximum core cross-section | without wire end ferrule 2.5 mm , with connector sleeves 1.5 mm |
| Housing base | plastic |
| Reduction factor r | 0.4 |
Сравнение
Избранное
