Пт-Пн: 9:00 - 18:00

Для оформления заявки добавьте оборудование
в корзину и сформируйте заказ
Цены носят информационный характер и не являются публичной офертой. Точную цену и срок поставки подтвердит менеджер при оформлении заявки
Доставка в любой регион России транспортной
компанией на Ваш выбор
| Параметр | Значение |
| Общие характеристики | |
| Артикул | 40242 |
| MTTF | 1510 a |
| Mission Time (T | 20 a |
| Diagnostic Coverage (DC) | 0 % |
| Operating voltage | 10 ... 30 V DC |
| No-load supply current | ≤ 20 mA |
| Switching frequency | 0 ... 180 Hz |
| UL approval | cULus Listed, General Purpose |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Ambient temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Degree of protection | IP68 / IP69K |
| Mass | 225 g |
| Time delay before availability | 80 ms |
| Voltage drop | ≤ 2 V |
| Note | Tightening torque: 1.8 Nm (housing) |
| Operating current | 0 ... 200 mA |
| Output type | 3-wire |
| Switching function | Normally open (NO) |
| Rated operating distance | 40 mm |
| Installation | non-flush |
| Output polarity | DC |
| Assured operating distance | 0 ... 32.4 mm |
| Reverse polarity protection | reverse polarity protected |
| Short-circuit protection | pulsing |
| Switching state indicator | LED, yellow |
| Connection type | screw terminals |
| Housing material | PA/metal with epoxy powder coating |
| Sensing face | PA |
| Hysteresis | typ. 5 % |
| Off-state current | 0 ... 0.5 mA typ. 0.1 µA at 25 °C |
| Standards | EN 60947-5-2:2007 EN 60947-5-2/A1:2012 IEC 60947-5-2:2007 IEC 60947-5-2 AMD 1:2012 |
| Core cross-section | up to 2.5 mm |
| Operating voltage indicator | LED, green |
| Actual operating distance | 36 ... 44 mm |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 % |
| Minimum core cross-section | without wire end ferrule 0.5 mm , with connector sleeves 0.34 mm |
| Maximum core cross-section | without wire end ferrule 2.5 mm , with connector sleeves 1.5 mm |
| Housing base | plastic |
| Reduction factor r | 0.39 |